Static Analysis of Frame Structure of Post-Stroke Tricycle Design Based on Solidworks Software 2012 with Material Type Variations


Analisa Statik Struktur Frame Desain Sepeda Roda Tiga Pasca Stroke Berbasis Software Solidworks 2012 dengan Variasi Jenis Material


  • (1)  Eko Siswono            Teknik Mesin, Universitas Muhammadiyah Sidoarjo  
            Indonesia

  • (2) * Mulyadi Mulyadi            Universitas Muhammadiyah Sidoarjo
    (*) Corresponding Author

Abstract

The body weight of post-stroke patients varies from one another, this can affect material selection. In this study, the researchers designed a three-wheeled frame using various types of material and the same material size including: galvanized pipe, stainless pipe (AISI 304), mild steel pipe (ASTM A36), Alloy Steel pipe to obtain a safe design for sufferers post-stroke, the skeletal design was analyzed statically using Soliworks 2012 software to obtain the results of analysis in the form of: Von Mises Voltage, Safety Factor (Strain) and Strain (Displacement). Static analysis of Post-Stroke Tricycle Design results obtained the greatest Von Mises Voltage value on ASTM A36 type material with a stress value of 154.5 N/mm2 (MPa) and the smallest stress value in Galvanized type material with a stress value of 150.8 N/mm2 ( MPa). Based on the results of the analysis of Safety Factors (Safety of Factor) so that the design can be said to be safe for patients after stroke, the type of material that must be used is Alloy Steel with a value of Safety Factor (Safety of Factor) of 5.49.

Author Biography

Mulyadi Mulyadi, Universitas Muhammadiyah Sidoarjo

Mechanical engineering

References

Rodika and M. L. Batan, “Sepeda Roda Tiga Untuk Pasien Pasca Stroke,” Jurnal Manutech, vol. 5, no. 2, pp. 8–57, 2013.

B. Setyono, “Perancangan Dan Analisis Kekuatan Frame Sepeda Hibrid “Trisona” Menggunakan Software Autodesk Inventor,” Jurnal IPTEK, vol. 20, no. 2, pp. 37–37, 2016. [Online]. Available: https://dx.doi.org/10.31284/j.iptek.2016.v20i2.43

R. Mariudin, Y. Gunawan, and Samhuddin, “Perancangan dan Analisa Frame Sepeda Pengangkut Gabah,” ENTHALPY, vol. 3, no. 4, 2018.

S. A. Alfath and A. H. A. Rasyid, “Analisa Pembebanan Dinamik pada Pengembangan Axle Main Landing Gear Pesawat Boeing 737-800 Menggunakan Pendekatan Finite Element,” Jurnal Teknik Mesin, vol. 6, no. 1, pp. 139–146, 2018.

T. Khairul, “”Desain Dan Simulasi Suspensi Sepeda Motor Dengan Solidwork,” Jurnal Rekayasa Mate- rial, vol. 1, no. 1, pp. 47–56, 2012.

Mulyadi and Ardi, “Perancangan Multipurphose Wheelchair,” Surabaya, 2012.

Published
2019-12-30
 
Section
Articles